As you know, the maintenance of the car must be carried out according to the instructions. Involverate, then often leads to deplorable results.
On the VAZ 2109 how to change the oil in the box many motorists know, but make mistakes. One thing to know exactly - its replacement is carried out every 35 thousand runs.
On the VAZ 2109 how to change the oil qualitatively - it is akin to art, the step-by-step instruction of the process of which is shown below.
The process of replacing the oil in the VAZ 2109 box
To carry out these works, the tools and the following accessories will be required:
- the key of the cape or head to unscrew the drain plug;
- jack for lifting the front of the machine;
- five-liter tank;
- plastic funnel with a narrow stack;
- rag;
- latex gloves.
Note. The manufacturer recommends the synthetic all-season transmission oil 80 W -85. GL -4432.
For a four-stage box, three liters are enough. If the box is five-speed, then three and a half liters are used.
Start performance of work
So:
- Preheat car drive into the garage room, where there is an observation pit.
- Under the back of the car to put anti-digit devices.
- Put a car on the handbrake (see).
- Remove the minus terminal from the battery.
- Right front side, along the move, raise the jack.
- Substitute a reliable reference device, in case of a jack refusal or other cases, not provided.
- Go down to the observation pit.
- With a sapuna on the box to remove the rubber stopper.
- Clean it from accumulated dirt, rinse.
- Clean the Sapun inside, use a soft wire for this.
- Put a plug in place.
Note: For work, there is a plastic five-liter canister to cut off the upper narrowing part and it turns out a good container for draining liquids.
Drain of oil
So:
- Caulted key, head carefully unscrew the drain bolt. The prepared capacity should be nearby.
Attention! It is necessary to remove the cork carefully and at the same time try to be a little away, in such a position, in order to prevent hot fluid on yourself.
- Mix in advance to the canister, remove the plug.
- Wait when it stands all the contents.
- Put a plug in place, tighten until it stops. Rinse a plum place.
- Remove the container, it can come in handy for lubricating old parts.
Note: Works are desirable to carry out, putting rubber gloves in the hands, because the oil absorbs the skin of the hands and is not flushed for a long time.
Fill
It is necessary:
- Remove the oil level control probe.
- Insert a plastic funnel, pour fresh. Fill the quantity required for the car.
- Wait 20-30 minutes so that it flows from the walls of the filler neck.
- Property Check the level, the oil should remain in the middle between the marks.
- Wipe the dipstick, put in place.
If the old box is installed on the car, there is no probe there. The plum cork is located next to the filler.
Then it is necessary to carry out the oil pump. It is a closed container with pumping pressure pump. Rubber hose with tip and tap for opening.
It is necessary:
- Unscrew the plug for fill, put nearby.
- In the tank, pour the required amount, create pressure using a pump.
- Insert into the hole of the fuel part, open the crane.
- Before notching the tip to prepare a plug.
- At the same time, take out the tip, instantly insert a plug. Split it.
- Wipe the box from the spilled liquid.
Note: Work carefully, carefully.
The replacement must be made due to the development of additives in it, which add manufacturers. They are used for heat removal, when working in box parts.
When moving in an urban art, the frequent switching of speeds and a sharp set of speed occurs. For this reason, the temperature in the working part reaches 300 0 S.
With such a temperature load, foaming of the oil begins, it loses the property for lubricating working parts. Therefore, manufacturers add additive ingredients.
With high-speed modes of motion, it is recommended to replace the oil after every 25-30 thousand mileage.
The technology of production of synthetic transmission oil with additives allows for operation in the critical temperature mode of the outer air. It does not lose its viscosity in neither frosts or in hot heat, therefore it is called all-season.
Some motorists are asked: "Do I need to rinse the box after draining oil?":
Recommendation.
It merges with a preheated box. Its temperature reaches the limits of 50 0 s, it has a liquid content.
Drain occurs under the tilt of the vehicle toward the drain neck. All formed small particles of metal, settle down at thenime.
The plug is located at the lowest point. Therefore, oil flows along with a precipitate, not leaving foreign impurities.
- Therefore, the flushing can not be performed.
It is possible to replace the oil in the transmission of the VAZ-2109 gearbox after watching the video, where the description is described in detail, the story about the order of work. In the photo you can explore the location of the probe, a drain neck.
See all the unexpected nuances for carrying out car maintenance. It is also necessary to read the instructions for the use of oils, the content of additives in its composition.
The price of a three-liter canister of synthetic transmission oil from a good manufacturer is within 1500 rubles. Independent oil change does not cause additional costs, subject to the rules of work, all procedures will be completed successfully.
