One of the key devices responsible for the functionality of the car. Domestic cars in the total mass of their reliance and unpretentious. If you figure it out, almost any repairs can be done with your own hands. We will tell about how the VAZ-2106 carburetor is adjusted.
System Setup
Before, you need to prepare a workplace. At the repair section should be perfectly clean. As on the operating table. Delete everything that can interfere normally work. Prepare the necessary tools and consumables in advance.
We start with the setting of the float chamber. If the system fails in this system, then there can be no speech on the normal operation of the power plant. Fuel is supplied or too enriched, or oversaturated oxygen. In the first case, the fuel consumption increases sharply, in the second - the engine "wants" or simply stalls. For the normal operation of the camera, the flow of the float must be set in the range of 0.8 cm.
Configure the operation of the power plant. For measurements, a gas analyzer will be required. We carry out the operation in the following sequence:
- We start the car and warm up the engine (if the motor is stalled, then it is possible to start it using the quality control bolts and the amount of fuel mixture).
- We twist the quality control bolts and the amount of fuel mixture until it stops, then gradually turn them into 2-3 turns.
- With the help of an adjustment bolt of the amount of the mixture, we adjust the operation of the motor at idle to 850-900 rpm.
- The mixture quality adjustment bolt is set up the power unit until it becomes stable and smoothly work.
- We smoothly screw the bolt (quality) until the engine when the engine does not start working with interruptions. Then gradually increase the rev. We carry out this manipulation in order to choose the optimal option in which the engine works without interruptions, and the fuel mixture is supplied as depleted as possible.
- Checking performance. Run the motor. Try to give additional "loads" on the power installation. Click, and then release the accelerator pedal or dramatically climb the brake pedal. With such manipulations, the motor should not blame. If this happened - you need to unscrew the "quality" bolt slightly. The fuel will "enrich" and the car should earn stable.
Traction adjustment sequence:
- remove the air filter;
- we carry out the gap measurement between the centers of the tip (permissible value of 80 mm);
- we unscrew the lock nut of the wrench ("8") and, rotating the tip, adjust the craving.
Output
Carburetor VAZ-2106 - Aggregate Reliable and unpretentious. will last for a very long time. We will not have the necessary maintenance in a timely manner, and you will not have problems with the machine.
