Generator belt Like the belt plays an important role in the "life" of the engine, it takes the transmission of torque from the crankshaft to the generator shaft. From the correctness of the installation and stretch of the generator belt depends, the correct charge of the battery, as well as the intensity of wear of the crankshaft bearings and the generator. In addition, the wrong stretch is harmful and the belt itself, its wear is increasing from insufficient stretching, as a rule, it appears in the form of a whistle due to a belt slippage on the shaft.
Excessive stretch is also harmful because the generator belt is stretched from this, and its bearings are twice as quick. Replacing the belt of the generator VAZ 2110 With the power steering (GUR), every 50-60 thousand runs should be made, or in case of severe stretching, or the appearance of cracks on the surface of the belt, or threads.
How to replace the VAZ 2110 generator belt do it yourself
- For convenience, it was decided to remove a tank with a hydraulic liquid and adsorber with fasteners.
- The key to "13" unscrew the lock nut.
- The same key must weaken the nut, which is attached to the generator to the installation bar.
- Next, remove the generator a bit on the side, weakening the strap stretch.
- Release the tensioning roller, it will allow even more to weaken the VAZ 2110 generator belt, after which it can be easily removed from the rollers.
- Now it will be necessary to remove the engine from the support, do not be afraid of the complex and dangerous in it. All you need is to unscrew two fastening bolts.
- Using the jack, you need to raise the engine slightly, for this, install it under the crankcase. When the engine pillow is raised you can reach the old belt.
- Shunt new VAZ generator drive belt 2110 Under the engine support, and proceed to install and reverse assembly.
- Tighten the tension roller in the extreme position, it will be the maximum belt tension.
- Now move the generator to the extreme position as close to the engine.
- It's time to produce the most difficult procedure called - the tension of the generator belt on the rollers. Skip the belt around all the rollers and pull the belt using the tensioner using the special key.
12. The tension of the generator drive belt should be such that with an effort 100 N (i.e. 10 kgf), it has fed 10-15 mm between the pulley of the generator and the crankshaft. The correct stretch stretch of the generator provides for the presence of a gap between the frame and the racking platform for the adjusting screw of ~ 14-20 mm. The arrows indicate the adjusting screws that are responsible for the degree of tension.
