There are many reasons why the stove may not work in the VAZ-2107. But the most common are a blown fuse, as well as an inoperative stove motor. If you can fix the first problem without disassembling the stove itself, then you will have to tinker a lot to get rid of the second one.
Instructions for removing the stove body on the VAZ-2107
In order to disassemble the stove, you must first remove its body. This should not be done while the negative terminal is connected to your vehicle's battery. Further, the procedure is as follows:
- remove the case of the glove box, as well as the instrument panel. It is also necessary to get rid of the panel in which the radio tape recorder is mounted;
- move the stove control lever to the right to the very end;
- we drain the liquid from the cooling system;
- we loosen the tightening clamps and disconnect the rubber hoses going to the heater pipe (these hoses are designed to drain fluid);
- unscrew the two bolts inside the engine compartment and remove the seal;
- there are also two bolts on the bracket for the stove control levers, they should be unscrewed;
- we slightly loosen the bolts holding the brackets for fastening the shells of the flexible rods;
- after disconnecting the rods, it becomes possible to dismantle the bracket. This should be done immediately;
- remove the right and left nozzles, which are responsible for heating the side windows. To do this, you need to apply a little force, since there are the case latches;
- unscrew the nut that secures the right air duct (side window heating), squeeze out the flaps and latches of the case, removing the air duct itself;
- we carry out a similar action with the left air duct;
- now we dismantle the stove fan casing and 4 spring holders;
- we unscrew the 4 nuts responsible for fastening the radiator casing, disconnect the wire on one of them (mass), and then remove the casing itself;
- proceeding to the removal of the air duct responsible for heating the windshield.
This completes the process of disassembling the stove on the VAZ-2107.
As you can see, it doesn't take too much time and effort. Everything can be done completely independently, without the help of specialists working at the service station.
The process of disassembling the stove body on the VAZ-2107
Of course, simply disassembling the stove cannot be made to work. To do this, it is necessary to repair or replace the motor itself or the radiator. But first you need to disassemble the case. The procedure is as follows:
- The fan motor has two spring clips. They should be removed, and then free the fan from the casing.
- We unscrew the nut with which the impeller is attached; it must be disconnected from the electric motor.
- After unscrewing the bracket securing nut, remove the air distribution cover of the fan casing.
- Inside the casing there are latches for the damper bodies of the air duct, which is responsible for heating the side windows. Remove the cover, then disconnect the rods.
- We loosen the bolts that secure the bracket that secures the sheath of the flexible rod of the damper of the air duct for heating the windshield, and remove it.
- We unscrew the nut of the bracket that secures the outlet and inlet pipes, remove the bracket and remove the stove radiator.
- Now you need to disconnect the stove tap and the outlet pipe. To do this, unscrew the fastening nuts.
- We slightly loosen the bolt of the bracket, due to which the shell of the flexible rod of the drive of the air intake cover works, and remove the rod itself.
- We unscrew all the nuts securing the air inlet and remove the cover from it.
